TattlerSolutions

A WiFi alternative in your exterior Hayes Smartmodem
Now with simulated audio dialing!


The WiFi Retromodem is a non-destructive alternative of the PCB in an exterior Hayes Smartmodem 1200 or 2400. Word: whereas it is going to match within the later Smartmodems, the LEDs of the Retromodem within the Hayes Optima collection aluminum instances are offset barely from the letters under. The Retromodem relies on the ZiModem software program obtainable on Github. A PDF of the README.md file might be discovered on the backside of this web page.
This new model additionally helps simulated audio dialing identical to an actual Smartmodem related to a cellphone line. See the video under.
The worth is $89 +$6 transport +$3 PayPal charge +CA tax if relevant.
To order, ship an e mail to information@tattlersolutions.com
INSTALLATION

Take away the 2 screws on the again, on the underside of the Smartmodem.

Take away the rear end-cap utilizing a small customary screwdriver.

Take away previous Smartmodem PCB.

Set up the WiFi Retromodem within the Smartmodem case. Reattach the rear end-cap. The 2 screws eliminated earlier aren’t used.

Connect the included +5 Volt AC adapter to the WiFi Retromodem. Don’t use the unique Smartmodem AC adapter as it is going to both not match or it may harm the Retromodem. Join the Retromodem to your laptop utilizing a 25 pin serial cable (not included). Run your favourite communication program and set the serial port to: 1200 baud, 1-stop bit, no parity, and no movement management. Plug within the AC adapter and activate the modem. After a couple of seconds, the Retromodem will ship a startup message to your terminal program and say, “READY.”

To configure the WiFi Retromodem, kind AT+CONFIG and choose “WIFI” to attach the Retromodem to your community. After you’ve related the Retromodem to your WiFi community, attempt connecting to a BBS by typing ATDT”telehack.com”

Further modem instructions might be discovered within the README.PDF file situated under.